Welcome to the official website of Shenzhen Taiyou Electronic Technology Co., Ltd!
Address: No.2, North 1st Road, Tianyang Third Road, datianyang Industrial Zone, Songgang town, Bao'an District, Shenzhen
Telephone:0755-33855605
Fax:0755-33855606
E-mail:twtaiyou@163.com
Website:http://www.twtaiyou.com
With the development of the plastics industry, the use of vertical injection molding machines in Shenzhen Taiyou is increasing, the demand for vertical injection molding machines is constantly expanding, and the competitiveness of enterprises is also constantly improving, which makes the development prospects of the vertical injection molding machine industry very impressive. So what are the safe operating procedures for vertical injection molding machines?
1. When installing the mold, you must confirm that the installation is correct and firm; before closing the mold, you must confirm that the nozzle cannot extend from the lower plane of the upper template to avoid damage to the machine.
2. At the beginning of the operation or when the operator alternates, the vertical injection molding machine must not be operated until the normal movement of the interlock and safety device is confirmed.
3. When the hand or part of the body needs to enter the mold, it must be done when the motor stops; do not directly touch the heated mold with your hands, use heat-resistant gloves; do not touch the plastic sprayed from the nozzle.
4. Keep the environment around the vertical injection molding machine always clean and avoid falling when walking on the ground covered by plastic, water and oil. Do not put anything on the vertical injection molding machine.
5. During the operation, do not touch any moving parts of the vertical injection molding machine to prevent pinching; do not wear gloves to operate the button to prevent the wrong button from being pressed and cause the vertical injection molding machine to move unexpectedly; simultaneous operation by more than two persons is strictly prohibited Vertical injection molding machine.
6. During operation, attention must be focused, and objects such as hands and tools are strictly prohibited from entering the dangerous area; if abnormal sounds and vibrations are found, the machine should be stopped immediately to find the cause and eliminate it, and then continue the operation.
7. When performing maintenance or repair work on the vertical injection molding machine, be sure to cut off the power of the vertical injection molding machine, confirm that the temperature has been sufficiently reduced, and then operate it, and hang a sign prohibiting power supply.
8. Operators and maintenance personnel must operate in accordance with the maintenance instructions and safe operating procedures of the vertical injection molding machine. During the operation, pay attention to the safety of the vertical injection molding machine and the vertical injection molding machine, and pay special attention to the inspection and use of safety devices to Ensure the safety and normal operation of the vertical injection molding machine.
9. Due to the high temperature around the nozzle and the heating cylinder, flammable items should not be placed around the vertical injection molding machine.
10. When cleaning the vertical injection molding machine, do not wipe the vertical injection molding machine with a dirty cloth, and do not directly blow the vertical injection molding machine with compressed air.
The safe operation rules of the vertical injection molding machine are shared here today. Vertical injection molding machine is a very important injection molding equipment, which can inject and fill the mold cavity to manufacture various shapes of plastic products.
Telephone
0755-33855605
13902910763
Mobile website
Mailbox
twtaiyou@163.com